Remote ID Working sample eg. 7400, 6550, 8500, 19303, 10550. Range 1 - 65500. See below on getting remote id

Remote ID Binary

Button Num

Output Hex

Output Base64 (For home assistant)

Generate code for home-bridge, home-assistant, openhab to send rf code from broadlink rm 2/rm pro/rm plus to livolo rf switch

Avoid using sample remoteID as permanent solution as your neighbour may have used the same code

How to select remote id

  1. It appears that the remote id is based on odd number of '1' in binary format
  2. Assuming your remote id is 7400, you will get 1110011101000 binary.
  3. Counting number of '1' will give you total 7 of '1' which is odd number
  4. So far, I have tested 3,5,7,9 and 11 '1' which works

How to teach your livolo for use the code (toggle)

  1. Generate the code using any btn(1-10). Use 10 if u wanna use on only or off only code
  2. Touch livolo switch for 5 sec till u hear a beep.
  3. Send the code. You will hear the beep when livolo learn correctly
  4. Send the same code again, your livolo switch should toggle on/off

How to teach your livolo for use the code (On Only/Off only)

    Your will need one remote id per button (not per switch).
  1. Generate the code using "on only(scn1)".
  2. Touch livolo switch for 5 sec till you hear a beep
  3. Touch the switch to turn on for on only.(Touch the switch to turn off for off only).
  4. Send the code. You will hear the beep when livolo learn correctly
  5. Send the same code again, your livolo switch should turn on. It does nothing if the switch already on
  6. Repeat using "off only(scn2)". On step 3, touch the switch to turn off before sending the code.
Add the "on only(scn1)" code to your home automation script as on
Add the "off only(scn2)" code to your home automation script as off

How to unlearn the code from switch

  1. Touch livolo switch for 5 sec till u hear a beep.
  2. Send the code. You will hear the beep twice when livolo unlearn correctly

Please reference this page if you reuse the code here